• All maintenance should be
carried out by qualified personnel.
• Clean and lubricate any
moving components.
• In case of rust, use some
grease on it.
• Ensure that the slider gate
is always well balanced.
• Ensure there are not binding / sticking of
the gates which can falsely trigger the obstruction sensing unit.
• Regularly test the slider gate motor to
ensure that the obstruction sensor unit is operating properly.
|
Problem
|
Possible cause
|
Solution
|
|
Handset(remote control)
doesn’t work or has too short-a range
|
Handset battery may be flat
Handset may not be coded
to the
Receiver Board
Receiver antenna not be fully extended
Radio interference may be affecting
your Receiver
|
Replace BatteryCode
Handset
(see Section 15) Extend
Aerial Remove anypossible external interference e.g. Baby Monitor
|
|
The gate doesn’t open or close
|
Power source may not be connected. Back
up battery may be exhausted
after prolong power failure
|
Ensure the transformer is connected to
the circuited board
Ensure the battery is connected to the
circuited board
|
|
The gate re-opens or stops during operation
|
Sensitivity may be set too light (Motor
may need more torque) Gate may be
obstructed
Photoelectric cells- Safety
Beams( where fitted) may be dirty
|
Increase motor torque
Check for obstruction
Clean and check PE cells
|
|
The gate auto opens rather then auto
closes
Open green led is on, but gate is close
Close red led is on but gate
is open
|
Motor & Limit switch may be wired I
reverse
|
Change motor on the circuit board &
re-adjust Limit switch
|
|
The motor spins but the
gate doesn’t open
|
The manual release may not be
engaged.
|
Ensure the manual release are
properly engaged and tighten onto the
gear
|
• Spare parts can be
purchased directly from us.
No comments:
Post a Comment